CALL US TOLL FREE : 877 222 5444

Be Knowledgeable about the Concrete Cutting Diamond Blade

Before proceeding with concrete cutting Dana Point CA, there are proper testing methodologies, which needed to be conducted for obtaining accurate and at the same time the desired project outcomes. You can actually use simple procedures in field conditions and at the same time verify their feasibility for testing the diamond cutoff wheels. There are a few aspects, which influence the performance of the diamond blades and needed to be considered for any kind of testing of the diamond cutting blades. These are:

• Material that is being cut
• SFPM or peripheral speed of the blade
• Depth of cut
• Feed rate
• Coolant being used and its application
• Operators of concrete cutting and their level of experience

All of the diamond blade makers carry out a certain level of testing of their products before release. For bringing about an improvement of their existing products, develop new products and compare against the competition, these methods are required. Generally, most of the blade makers are able to engineer the diamond blade tests. When provided with the appropriate equipment that is in good condition, the expert operators are aware of the appropriate use of diamond blades, application of the coolant, regulating the feeds and speeds, appropriate mounting of the material that is to be cut, and other suggested conditions for using the concrete cutting Dana Point CA wheels properly. When used under these circumstances, the results that are obtained within the facilities of the manufacturers are usually the best as desired.

Things to Consider

Before evaluating the performance of a diamond blade, it is crucial to take into account that there are several factors, which may affect the performance of the blade. Various kinds of testing procedures are carried out for allowing the users to understand the functions of the blade in terms of its life, straightness of the cut, rate of cut and level of surface finish as opposed to the material which is being cut. However, it is important to remember that the concrete cutting methods of various manufacturers might vary, which lead to variations in the results. However, there are 3 important factors that needed to be tracked to understand the diamond blade performance better:

Efficiency of Cut: This is the rate at which the diamond blade is able to cut an area per unit time. The cutting efficiency of a blade reflects its sharpness, which is the primary aspect that should be considered by the user. It should satisfy the cutting requirement of the user. It is a fact that with a coarse grit and lower concentration of diamond, the sharpness of the blade can be enhanced.

Lifespan: The service life of the concrete cutting diamond blade reflects its durability. It is usually measured in terms of the total area that it can cut before getting worn out. Once the cutting efficiency needs are met with the user standards, consumers then need to consider the service life of the blade.

Processing Quality: This represents the manufacturing quality of the diamond blade. It is the quality of the cutting material. While evaluating the processing level of the blade by performing testing, the factors that needed to be kept in mind are the roughness of the surface, integrity of the edges, parallelism of the cutting sides, and flatness.

We Will Call you












    Contact us on :

    Lancaster : 661-723-0900
    Los Angeles: 323-774-5919
    Orange County: 714-635-5944
    Palm Springs: 760-568-0261
    Paramount: 562-634-4021
    San Bernadino/Riverside: 909-825-8401
    Van Nuys: 818-994-0551